Payload guide
Car-licence trucks: how 4,500 kg GVM affects payload
GVM is the truck’s maximum permitted loaded mass. It is not the freight allowance. The chassis, body, occupants, accessories and load must all fit within that limit, while also staying within the axle and component limits.
Start with the registered GVM
For a truck registered at 4,500 kg GVM, 4,500 kg is the total mass ceiling for the loaded vehicle. Use the vehicle’s registration and approved ratings, not an advertised chassis range. Fitting a lighter body does not itself increase or change the approved GVM.
Work from the complete vehicle
For planning, subtract chassis tare, the body, accessories, occupants and other equipment from the registered GVM. Allow for the actual operating configuration, including fuel or batteries and anything not already included in the tare figure. Avoid subtracting the same equipment twice.
Indicative freight allowance = registered GVM − complete vehicle mass before freight.
A weighbridge measurement of the completed vehicle helps establish the real starting mass. Check how the chassis maker defines tare and confirm the operating loads and axle distribution before relying on a payload figure.
Body weight is one part of the allowance
The SuperLight™ Pantech — car licence, 3 pallet is listed at approximately 545 kg, ±10%, confirmed at quote, with 4,300 mm external length × 2,200 mm external width × 2,100 mm internal height. These figures alone do not establish a completed truck’s payload. Doors, steps, lifts, restraint equipment and mounting arrangements need to be considered in the final configuration.
Explore the SuperLight™ Pantech, EasySlider™ Curtain or ThermoLight™ Refrigerated.
Axle limits still apply
A truck can be below its total GVM and still exceed an axle or component rating. Load placement, wheelbase, body position, rear overhang and accessories all affect the distribution. Keep within the applicable front and rear axle, tyre and other component limits as well as the overall vehicle rating.
Check the driver’s licence and conditions
Official NSW and Victorian guidance allows a car-licence vehicle up to 4.5 tonnes GVM, subject to seating and licence conditions. Check the rules that apply to your licence, registration and route; do not assume an electric truck automatically qualifies for a higher car-licence GVM.
Licence exemptions are specific. For example, Victoria’s published heavy-vehicle exemption process addresses minimum licence-holding time on hardship or previous-experience grounds; it is not a general permission to drive a heavier truck on a car licence. Mass or road-access permissions also do not replace the correct driver’s licence. Obtain written confirmation from the relevant licensing authority for any proposed exception.
Official references
- NSW Government: licence classes
- Transport Victoria: licence categories
- Transport Victoria: heavy-vehicle licence exemptions
- NHVR: manufacturer’s mass limits
- NHVR: load distribution
Figures and linked guidance last reviewed: November 2026. This guide supports specification planning; it does not approve a vehicle, load or licence entitlement.
Your truck. Your specification.
Get specs & pricing
Tell us your chassis, wheelbase (mm), registered GVM and the load you need to carry.
Required: Name, email and what you need. Optional: Mobile and truck or company details.